Auger Motor Assembly - GE Profile PFSS6NKW Technical Service Manual

Auger Motor Assembly

To remove the auger motor assembly:
1. Remove the ice bucket and icemaker. (See
.)
Bucket and Icemaker
2. Note the routing of the auger motor assembly
wire harness, then disconnect the harness.
Disconnect
3. Push the release tab on the front of the auger
motor assembly to the right, then pull the auger
motor assembly out of the iceroom.
Release Tab
Ice
Auger Assembly Components
Fresh Food Door Switch
Note: On early production models, the black wire
is not connected to any circuit. It was added to
protect the exposed unused terminal.
On later production models, the separate wiring will
be changed to a plug-in harness and the black wire
will be removed.
SWITCHED
NEUTRAL
BLU
Later Production
– 61 –
Ice Room Sensor
Cube Solenoid
Auger Motor
BWN
Early Production
L1