Dispenser Assembly - GE Profile PFSS6NKW Technical Service Manual

Dispenser Assembly

The dispenser assembly includes the duct door, duct
door motor, cam and cam switches, and funnel.
The assembly is held to the dispenser recess with 2
screws and 1 tab.
To replace the dispenser display:
1. Remove the dispenser display assembly. (See
Dispenser Display Assembly
2. Disconnect the motor and cam switches wire
harnesses.
Disconnect
3. Remove the 2 Phillips-head screws. Lower the
assembly down to disengage the tab and pull
the dispenser assembly from the recess.
.)
Tab
– 54 –
Caution: Wiring is fi rmly attached to the cradle
switch. To prevent breaking mounting pins, care
must be taken when removing wiring.
4. Carefully remove the cradle switch from the
dispenser assembly.
Note: When installing the dispenser assembly into
the recess, ensure the water outlet is placed inside
the funnel and tab is inserted into recess.
Funnel
Cradle Switch
Water Outlet
(Continued next page)