Checking The Parking Brake; Adjusting The Throttle Wire; Replacing The Air Filter - Jonsered Frontrider FR2315 MA Operator's Manual

Checking the parking brake

Check that the brake is correctly adjusted by placing the
machine on a slight downhill slope with the clutch disengaged
and activating the brake.
When the machine does not stand still, the brake should be
adjusted.
Adjusting the brake
1 Remove the protective cover.
2 Loosen the locking nuts (1).
3 Tension the cable using the adjuster screw (2) until the
play in the cable is taken up.
4 Tighten the locking nuts (1) after adjustment.

Adjusting the throttle wire

The throttle cable may need to be adjusted, if the engine does
not respond as it should when accelerating, if it produces
black smoke or maximum revs are not reached.
1 Release the clamping screw that secures the wire casing
and set the choke control to maximum choke.
2 Pull the choke wire casing to the far right and tighten the
clamping screw.
18 –
English
Maintenance
2
1
1
3 Pull back the throttle to the full throttle position and check
that the choke is no longer actuated.
Replacing the air filter
If the engine seems to lack power or does not run smoothly
this may be because the air filter is clogged. It is therefore
important to replace the air filter at regular intervals (see
Maintenance/Maintenance Schedule for the correct service
interval).
Replace the air filter as follows:
1 Open the engine cover.
2 Loosen the knobs holding the filter cover in place and
remove it.
3 Remove the air filter cover.
4 Lift out the air filter cartridge from the fan housing.
IMPORTANT INFORMATION
Do not use compressed air to clean the paper filter.
Do not oil the paper filter. They must be fitted dry.
5 Slide the filter onto the air hose.
6 Push the filter cartridge in place.
7 Refit the air filter cover.