Starting The Heater For The First Time; Location Of Controls; Direct Operation - Lopi 6015 HO Owner's Manual

8

Starting the Heater for the First Time


Burn the heater at a low setting with the blower off for an extended period (up to 48 hours). This will
cure the painted surfaces. Fumes from the paint curing and oil burning off the steel will occur. This
is normal. We recommend opening a window to vent the room.

Condensation may appear on the glass each time you start the heater - this is normal.

Blue Flames will occur on the heater when it first comes on. After fifteen minutes the flames will turn
a more realistic yellow and orange color.

Verify the batteries are installed (see page 14).

Location of Controls

Direct Operation

The fireplace may be directly operated from the battery holder (on the far left of the fireplace - accessed by
removing the concealment cover – see "Glass Removal"). The three positions are below:
ON – Burner turns on (regardless of transmitter settings).
OFF – Burner turns off (regardless of transmitter settings).
REMOTE – Burner is controlled by the transmitter.
Battery Holder
NOTE: When the battery holder switch is turned to ON or OFF, the mode settings (Flame Height, etc.) will
remain in the same state as before the switch was moved (i.e.: the IFC "remembers" the last setting). If
you wish to adjust the mode settings use the transmitter mode button to adjust the settings. The
thermostat and burner on/off operating functions will not work on the transmitter.
© Travis Industries
Operation
Most features will be
controlled by the
included remote.
4131220 100-01371