Wolf OG30 Installation Manual page 21

Outdoor Grill Installation
Install Side Burner to Cart
AUXILIARY HARNESS (IF APPLICABLE)
If you purchased a Wolf outdoor grill with serial number
listed below, you will have received an auxiliary harness. If
this harness has not been provided with your side burner,
contact Wolf customer care 800-222-7820.
Auxiliary Harness
GRILL
Model OG30
Model OG36
Model OG42
1) If still installed, rear panel of cart must be removed to
install auxiliary harness. Remove rear panel by
removing four screws. Refer to illus 5 on page 16.
2) With wire ties provided, attach auxiliary harness to fire
box fin or existing wire harness. 4-pin connector
cluster should be placed facing rear of grill and 2-pin
connector should be placed facing front. Harness must
be tied down tightly and must not touch grill fire box.
Refer to illus 21.
Illus 21.
PRIOR TO SERIAL NUMBER
11364339
11363946
11363911
3) If connected, disconnect transformer 4-pin connector
at rear of grill. Attach one of 4-pin connectors to 4-pin
connector attached to grill. Attach other 4-pin connec-
tor to 4-pin connector from transformer.
4) Remove unpopulated connector housing from wire
harness coming from grill. Insert each connector
housing from side burner harness to corresponding
housing on grill harness and on auxiliary harness.
There are two connections to be made. Refer to illus 16
and 17 on page 19.
5) Reinstall rear panel of cart.
21
wolfappliance.com