Wolf OG30 Installation Manual page 17

Outdoor Grill Installation
Install Side Burner to Cart
INSTALL SHROUD
4) Place shroud alignment tool (provided) with lip placed
in gap between grill and side burner shroud as shown
in illus 9.
5) To properly align front of shroud, push alignment tool
back until center block of alignment tool is flush
against front vertical flange of shroud.
6) Align front of shroud (up and down) with alignment tool
until top of tool is flush with top surface of grill bullnose
(front ledge), and align shroud (front to back) with tool
until front of tool is flush with front of bullnose. Tighten
upper front 10-32 machine screw. Refer to illus 9.
7) Remove alignment tool from front of shroud and
replace at rear of shroud. Align rear of shroud (up and
down) with tool until top of tool is flush with top
surface of grill. Tighten upper rear 10-32 machine
screw. Refer to illus 10.
IMPORTANT NOTE: Verify with alignment tool that front
of shroud did not move out of alignment. Realign if
necessary.
ALIGNMENT
TOOL
UPPER
SCREW
SURFACES
FLUSH
Illus 9.
SURFACES
FLUSH
ALIGNMENT
UPPER TOOL
SCREW
Illus 10.
8) Remove alignment tool and tighten two remaining
10-32 machine screws to slots just below the upper
screws.
5 3
9) Install two / x / hex drive shoulder screws into
16 8
lower holes of shroud and through cart. Place two
1
/ –20 hex nuts from inside of cart and tighten. Refer
4
to illus 11.
SHOULDER
SCREWS
HEX NUT
(INSIDE CART)
Illus 11.
17
wolfappliance.com