Wolf OG30 Installation Manual page 13

Outdoor Grill Installation
Gas Leak Testing
IMPORTANT NOTE: Never use the outdoor product
without first testing the gas line connections for gas leaks.
Perform a gas leak test each time the LP gas cylinder is
connected to the regulator and any time part of the gas
system is disconnected or replaced. This applies to
natural gas as well as LP gas. Perform a leak test at least
once each year whether the LP gas cylinder has been
disconnected or not.
IMPORTANT NOTE: To prevent fire or explosion hazard,
do not smoke or permit sources of ignition in the area
while performing a leak test. Perform the gas leak test
outdoors in a well ventilated area.
Have a dealer check the LP gas cylinder for deterioration
when the tank is filled in accordance with regulations.
Immediately replace the cylinder if any deterioration is
found.
DO NOT use an open flame to check for gas leaks.
Use of an open flame could result in a fire, explosion
and bodily harm.
GAS LEAK TESTING PROCEDURE
1) Prepare a leak testing solution of soapy water by
combining a mixture of half liquid soap and half water
in a spray bottle.
2) Verify that all control knobs are in the OFF position.
3) Turn the cylinder valve knob counterclockwise one turn
to open.
4) Apply the leak testing solution by spraying on the pipe
joints, fittings and hose. Bubbles in the soap and water
solution indicate that a gas leak is present.
5) Stop the leak by tightening the loose joint or by
replacing the faulty part with a replacement part
recommended by the Wolf. Do not attempt to repair the
cylinder valve if it should become damaged. The
cylinder must be replaced.
6) If you are unable to stop the leak, shut off the gas
supply at the cylinder valve. Remove the LP gas
cylinder. Call Wolf factory certified service. Do not use
the outdoor product until the leak has been fixed.
7) Push in and turn any control knob to the ON position to
release pressure in the hose and manifold.
8) Turn the control knob to the OFF position.
13
wolfappliance.com