>Change ID
00000001
>Change ID
001
>Change ID
_
OK?
002
>Change Password
>Change Password
_
the cursor right and left. Enter a password consisting of between 0
and 16 digits.
Note If you enter the incorrect administrator ID or password,
the Wrong ID or Wrong Password message appears and
the input screen then reappears. Re-enter the ID or password
correctly.
3
Once you enter the correct ID and password, the Admin (change)
screen appears. (E.g.: Where the administrator ID is 00000001)
Each time you press or , the following settings to be changed
appear in succession.
• Change ID
• Change Password
Note If a change is required, refer to the procedures in
Change ID (Administrator ID change) and Change Password
(Administrator Password change) below.
4
Press [OK] again. The administrator ID and password are confirmed.
5
Press [MENU]. The display returns to Ready.
Change ID (Administrator ID change)
You can use this to change the administrator ID.
1
In step 3 in Password (Administrator Password input) above, press
or while the Admin (Change) screen is displayed until >Change
ID appears. (E.g.: Where the administrator ID is 001)
2
When you press [OK], a blinking cursor (_) appears.
3
Press or to increase or decrease, respectively, the value at the
blinking cursor. Enter the ID to be changed. Use and to move the
cursor right and left. Enter an ID consisting of between 1 and 16
numbers.
4
Press [OK]. A confirmation screen appears. (E.g.: Where the
administrator ID is changed to 002)
5
Press [OK]. The new administrator ID is confirmed.
6
Press [MENU]. The display returns to Ready.
Change Password (Administrator Password change)
You can use this to change the administrator password.
1
In step 3 in Password (Administrator Password input) above, press
or while the Admin (Change) screen is displayed until >Change
Password appears.
IMPORTANT The administrator password is not displayed.
2
Press [OK]. A blinking cursor (_) appears.
4-95
Using the Operation Panel