Subnet Mask - Kyocera ECOSYS P6021cdn Operation Manual

>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
network address (or network section) that identifies the network to which
that computer belongs (or more specifically, the computer's network
interface). Bit strings (IP addresses) that are unique throughout the entire
Internet system are allocated to each computer or interface.
The IP addresses currently used on the Internet (IPv4) have a fixed length
of 32 bits.
Note When you enter the IP address, be sure to set the DHCP
setting to Off.
1
Press  while >TCP/IP
2
Press  or  repeatedly until >>IP Address appears.
3
Press [OK]. A blinking cursor (_) appears.
4
Press  or  to increase or decrease, respectively, the value at the
blinking cursor. You can set any value between 000 and 255. Use 
and  to move the cursor right and left.
5
Display the desired IP address and press [OK].
6
Press [MENU]. The display returns to Ready.
Subnet Mask (Subnet mask setting)
The subnet mask is a way of augmenting the network address section of
an IP address.
A subnet mask represents all network address sections as 1 and all host
address sections as 0. The number of bits in the prefix indicates the
length of the network address. The term "prefix" refers to something
added to the beginning and, in this context, indicates the first section of
the IP address.
When an IP address is written, the length of the network address can
indicated by the prefix length after a forward slash (/). For example, "24"
in the address "133.210.2.0/24". In this way, "133.210.2.0/24" denotes
the IP address "133.210.2.0" with a 24-bit prefix (network section).
This new network address section (originally part of the host address)
made possible by the subnet mask is referred to as the subnet address.
Note When you enter the subnet mask, be sure to set the DHCP
setting to Off.
1
Press  while >TCP/IP
2
Press  or  repeatedly until >>Subnet Mask appears.
3
Press [OK]. A blinking cursor (_) appears.
4
Press  or  to increase or decrease, respectively, the value at the
blinking cursor. You can set any value between 000 and 255. Use 
and  to move the cursor right and left.
5
Display the desired subnet mask and press [OK].
6
Press [MENU]. The display returns to Ready.
4-49
Using the Operation Panel
On > is displayed.
On > is displayed.