Oki B721 User Manual page 125

configuration for "Phase1 Proposal" in
Your Printer" P.124.
15
Click [OK].
16
On the [Key Exchange Security
Methods] window, click [OK].
17
On the [Key Exchange Settings]
window, click [OK].
18
On the IP security policy properties
window, select the [Rules] tab.
19
Click [Add].
20
On the [Security Rule Wizard], click
[Next].
21
On the [Tunnel Endpoint] screen,
select [This rule does not specify a
tunnel] and then click [Next].
22
On the [Network Type] screen, select
[All Network Connections] and then
click [Next].
23
On the [IP Filter List] screen, click
[Add].
24
On the [IP Filter List] window, click
[Add].
25
On the [IP Filter Wizard], click [Next].
26
On the [IP Filter Description and
Mirrored Property] screen, click
[Next].
27
On the [IP Traffic Source] screen, click
[Next].
28
On the [IP Traffic Destination] screen,
click [Next].
29
On the [IP Protocol Type] screen, click
[Next].
30
Click [Finish].
31
On the [IP Filter List] window, click
[OK].
32
On the [Security Rule Wizard], select
the new IP filter from the list and then
click [Next].
33
"Configuring On the [Filter Action] screen, click
[Add].
34
On the [Filter Action Wizard], click
[Next].
35
On the [Filter Action Name] screen,
enter a [Name] and a [Description]
and then click [Next].
36
On the [Filter Action General
Options] screen, select [Negotiate
security] and then click [Next].
37
On the [Communicating with
computers that do not support
IPsec] screen, select [Do not allow
unsecured communication] and then
click [Next].
38
On the [IP Traffic Security] screen,
select [Custom] and then click
[Settings].
39
On the [Custom Security Method
Settings] window, configure the
settings and then click [OK].
● Configure the AH and ESP settings to the same
40
On the [IP Traffic Security] screen,
click [Next].
41
Select [Edit Properties] and then click
[Finish].
42
On the filter action properties window,
select [Use session key perfect
forward secrecy (PFS)] if you want to
enable Key PFS.
43
Select [Accept unsecured
communication, but always respond
using IPsec] if you perform IPSec
communication by the IPv6 global
address.
44
Click [OK].
45
Select [New Filter Action] and then
click [Next].
46
On the [Authentication Method]
screen, select the authentication method
you want and then click [Next].
- 125 -
Changing Network Settings From the Web Page
Note
settings as configured for the "Phase2 Proposal" in
"Configuring Your Printer" P.124.
4