Default Settings - Buffalo TeraStation 5000 User Manual

Recovery I43
Unsupported HW
Recovery I44
Disk1 not found
Recovery I45
Recovery Failed
RAID ARRAY I46
RMM+Processing
SYSTEM I47
Don't Power Off
FailOver I48
PushFuncToStart
FailOver I49
LostMainTarget
FailOver I50
Maintenance mode
FailOver I51
Initializing
New Firmware I52
Available
BackupTask xx I54
Backup Failure
Recovery I55
RecoveryAuthFail
Surveillance I56
Lack of License
Surveillance I57
No free space
Surveillance I58
Recording Failure

Default Settings

Administrator's Name
Password
Shared Folders
The TeraStation was started from the USB
recovery device, but the system cannot
be recovered from this USB recovery
device.
Recovery from the USB recovery device
was initiated, but the drive 1 was not
detected.
Recovery failed.
Data migration or conversion (RAID
migration) is in progress.
This TeraStation is ready to become the
failover backup for the main TeraStation.
The main TeraStation in the failover
configuration cannot be found.
Failover maintenance is in progress.
Initializing the failover configuration.
A new firmware version has been
released.
xxth backup task failed.
Authentication during recovery of
settings failed.
There are not enough surveillance
camera server licenses.
There is not enough space to save
additional surveillance video.
Video not recorded.
admin
password
"share" (for both Windows and Mac computers). The recycle bin is enabled
on "share" by default.
-
Make sure that Disk 1 is present and fully
inserted in its slot.
-
Do not turn off the TeraStation power.
Hold down the function button on the
front of the target TeraStation until it stops
beeping to accept failover backup status.
Make sure that the main TeraStation is on,
working, and connected to the network.
Do not turn off the TeraStation power.
Do not turn off the TeraStation power.
Update the firmware.
Make sure that the xxth backup task is
configured correctly. Make sure that the
NAS is not in standby mode. If the backup
task still fails, check the network, backup
source, and backup destination.
Settings can only be restored for the
TeraStation whose settings were originally
saved. To restore settings, insert the USB
memory device, move the Boot Mode
switch on the rear of the TeraStation to the
USB position, and restart the TeraStation. Or,
settings can be restored in Settings with the
TeraStation powered on.
Purchase and register an additional license.
Delete or move some of the stored video.
Check your settings. Also, use the utilities
provided with your camera to check that
the camera is operating correctly.
169