Amber; Default Settings - Buffalo linkstation 500 User Manual

Amber

If there is a status message, the power LED will blink amber. You can also see any status messages in NAS Navigator2.
Information Code
I12
I13
I16
I18
I19
I20
I21
I22
I23
I25
I28
I46
I52
I54

Default Settings

Administrator's Name
Password
Shared Folders
DHCP Client
Microsoft Network Group Setting
SMB
AFP
FTP
NTP
DLNA
iTunes Server
BitTorrent
Wake-on-LAN
RAID Mode
Description
Operating in degraded mode.
Formatting RAID array X.
Creating RAID array X.
Rebuilding RAID array X.
Note: Transfer speeds are slower
during the rebuilding process.
Writing 0s to RAID array X,
erasing all data.
Formatting hard drive X.
Checking hard drive X.
Erasing the data for hard drive X.
System is being initialized.
Updating the LinkStation
firmware.
Formatting USB hard drive.
Data migration or conversion
(RAID migration) is in progress.
A new firmware version has
been released.
A backup job has failed.
admin
password
"Public" and "admin" (for both Windows and Mac computers).
Normally, the LinkStation will get its IP address automatically from a DHCP
server on the network. If no DHCP server is available, then an IP address will
be assigned as follows:
IP address: IP address will be assigned starting from "169.254".
Subnet mask: 255.255.0.0
WORKGROUP
Enabled
Disabled
Disabled
Enabled
Enabled
Disabled
Disabled
Enabled
RAID 1 (LS520D)
Corrective Action
-
-
-
-
-
Don't turn off the LinkStation.
Don't turn off the LinkStation.
-
-
-
Don't turn off the LinkStation.
Don't turn off the LinkStation.
Update the firmware.
Make sure that the backup job is configured correctly,
and that the NAS is on and not in standby mode. If the
backup job still fails, check the status of the NAS and
the backup source and destination.
123