Table of Contents
Advertisement
No audio when
Amplifier turn-on lead is
Turn the unit off and check each wire for a possible
operating the unit
shorted to ground or
short. If the amplifier turn-on lead shorts out, cover it
with amplifiers.
excessive current is required.
with insulation such as tape.
Disc is dirty.
Clean the disc with a soft cloth.
Replace with a fuse of the same amperage. If the
fuse blows again, consult your store of purchase.
With the SLOPING CONSOLE open, press and hold
the
[~]
button for 3 seconds or longer.
The foreign matter is forcibly ejected.
Consult your store of purchase.
1. Check the speaker connection.
2. Turn down sound volume. Function can also be
restored by turning the power off and on again.
3. If the sound is muted again, consult your store of
purchase.
Turn off the power, then
remove the DCP by
referencing
"Removing
the DCP" (ct. page 10).
Press the reset button for
about 2 seconds with a
thin rod.
Use MP3IWMA files encoded properly.
Incorrect wiring.
Files are not recognized as
Use MP3IWMA files encoded properly.
an MP3IWMA file.
There is a disc other than a
compact disc or foreign
matter already in place.
File system is not correct.
Use IS09660 level 1, 2 or JOLIET or Romeo file
system.
The microprocessor has
malfunctioned due to noise,
etc.
The speaker protection
circuit is operating.
DCP or main unit connectors
Wipe the dirt off with a soft cloth moistened with
are dirty.
cleaning alcohol.
Disc is heavily scratched or
Replace with a disc with no scratches.
warped.
MP3IWMA files are absent in
Write MP3IWMA files onto the disc properly.
a disc.
MP3IWMA files are not
encoded properly.
Power does not
turn on.
(No sound is
produced.)
Sound is cut or
skipped.
Noise is
generated or
noise is mixed
with sound.
Nothing happens
when buttons are
pressed.
DXZ855MP
41
Advertisement
Table of Contents
