Table of Contents
Advertisement
-
~.
Power does not turn
on.
(No sound is pro-
duced.)
Cause
Fuse is blown.
Measure
Replace with a fuse of the same amperage. If
the fuse blows again, consult your store of pur-
chase.
Incorrect wiring.
Consult your store of purchase.
) J - - - - - - - - - - - - - - - t - - - - - - - - - - - t - - - - - - - - - - - - - - - - - - - - - - - - - i
No sound output
Power antenna lead is shor- 1. Turn the unit off.
when operating the
ted to ground or excessive
2. Remove all wires attached to the power anten-
unit with amplifiers or
current is required for
na lead. Check each wire for a possible short
power antenna
remote-on the amplifiers or
to ground using an ohm meter.
attached.
power antenna.
3. Turn the unit back on.
)
4.
Reconnect each amplifier remote wire to the
power antenna lead one by one. If the amplifi-
ers turn off before all wires are attached, use
an external relay to provide remote-on voltag@
(excessive current required).
"
c
Nothing happens
when buttons are
pressed.
Display is not accu-
rate.
The microprocessor has
malfunctioned due to noise,
etc.
Turn off the power, then
press the
[RELEASE]
button and remove the
DCP.
Press the reset button
with a thin rod.
DCP or main unit connec-
tors are dirty.
Compact disc cannot
Another compact disc is
be loaded.
already loaded.
Sound skips or is noi-
Compact disc is dirty.
sy.
Compact disc is heavily
scratched or warped.
Wipe the dirt off with a soft cloth moistened with
cleaning alcohol.
Eject the compact disc before loading the new
one.
Clean the compact disc with a soft cloth.
Replace with a compact disc with no scratches.
o
(J
Sound is bad directly
after power is turned
on.
Water droplets may form on
Let dry for about 1 hour with the power on.
the internal lens when the
car is parked in a humid
place.
~
Poor sound quality
Q
32
DXZ925
The equalizer levels are too
high.
If the equalizer levels are too high, the sound
may distort. Lower the equalizer levels.
Advertisement
Table of Contents
