Rear Panel Connections; Rear Panel Connectors; Inputs - Extron electronics PVS 405D User Manual

Rear Panel
Connections
This section describes which cables to connect to a PVS 405D Switcher.

Rear Panel Connectors

The illustration below shows the rear panel features of the PVS 405D.

INPUTS

INPUTS
1/2 3/4
POWER SIG LINK SIG LINK
12V
3A MAX
PVT IN PVT IN PVT IN PVT IN
12 1
Inputs
a
b
c
d
e
7 5
PVS 405D
OUTPUT OUTPUT AUDIO OUT AUDIO OUT
PAGING
SENSOR
L R
VOICELIFT
+V
HDMI
INPUT 5 AUX
L R
6 3 4
2
Figure 2. PVS 405D Rear Panel Features
Inputs 1/2 and 3/4 — Connect up to two PVT SW HDMI RGB D or
PVT SW HDMI D wallplates (four input sources) to these two RJ‑45 female
connectors using Shielded Twisted Pair (STP) cable. These four inputs can be up
to four HDMI with embedded audio or two HDMI and two high resolution computer
video and audio sources or any combination of both. The RGB input is digitized at
the PVT input wallplate. The front panel input selection button toggles the inputs 1
through 4 as required. See
Input 5 — Input 5 is a dedicated audio only input for an auxiliary, stereo, line‑level
analog audio signal from an output source such as iPod device or an MP3 player.
Connect a cable from the source to this 5‑pole captive screw connector. It can be
wired as balanced or unbalanced. See
Aux audio port — Connect an aux audio device to this 3.5mm captive screw 3‑pole
connector for dedicated mono audio only input.
VoiceLift port — This RJ‑45 jack is dedicated for use with the optional VLR 102
VoiceLift Receiver for integration of a VoiceLift Microphone system.
NOTE: To install the VoiceLift Microphone system, see the VoiceLift Installation
Guide, supplied with the device.
Paging Sensor port — Connect the optional Priority Page Sensor (PPS 35) to this
port, to enable program audio interruptions during paging system broadcasts.
NOTE: The Extron Priority Page Sensor Kit (PPS 35, part #70-1064-01) is an
optional accessory, purchased separately. The switcher also supports the
Priority Page Sensor kit part number 70-619-01. To install a Priority Page Sensor
system, see the relevant installation guide supplied with the device.
8
AMPLIFIED AUDIO OUT AMPLIFIED AUDIO OUT
L
DO NOT
GROUND
OR SHORT
4/8
SPEAKER
OUTPUTS
CLASS 2 WIRING
OVER PVT REMOTE
IR RS-232
S G Tx Rx G
9
10
"Connector Wiring" for wiring details.
"Connector Wiring" for wiring details.
PVS 405D Switcher • Rear Panel Connections
11
LAN 1 LAN 2 LAN 3
R
4