Installing The Smartcard Reader - Fujitsu FUTRO S550 Operating Manual

System expansions

Installing the SmartCard reader

SmartCardreader
If not already installed, you can fit a SmartCard reader.
5
5
3
2
1
4
► Connect the cable to the SmartCard reader (1) and to the connector on the mainboard (2).
► Remove the cross-beam (3).
► If necessary, remove the PCI board, (see "Closing the casing", Page 17).
► With the component side facing downwards, insert the SmartCard reader on
the securing lug in the direction of the arrow (4).
► Secure the SmartCard reader onto the carrier with the screws (5).
► Close the casing (see "Closing the casing", Page 17).
Make sure that the cables are not trapped between the casing and the components.
18 - English A26361-K528-Z221-1-7419, edition 3