Replacing The Lithium Battery - Fujitsu FUTRO S550 Operating Manual

Replacing the lithium battery

In order to permanently save the system information, a lithium battery is installed to provide
the CMOS-memory with a current. A corresponding error message notifies the user when the
charge is too low or the battery is empty. The lithium battery must then be replaced.
Incorrect replacement of the lithium battery may lead to a risk of explosion!
The lithium battery may be replaced only with an identical battery or with
a type recommended by the manufacturer.
Do not dispose of lithium batteries with household waste. They must be disposed
of in accordance with local regulations concerning special waste.
When replacing the Lithium battery, make sure that you insert it the
right way round, see diagram.
Replacing, Battery Replacing,lithium battery Lithium battery, Replacing,
The lithium battery holder exists in different designs that function in the same way.
1
► Open the casing (see
► Press the catch in the direction of the arrow (1).
The battery jumps out of the holder slightly.
► Remove the battery (2).
► Push the new lithium battery of the identical type into the holder (3) and
press it down until it engages.
► Fasten the catch (4).
► Close the casing (see
A26361-K528-Z221-1-7419, edition 3
2
"Opening the casing", Page
"Closing the casing", Page
4
3
16).
17).
System expansions
English - 23