3. Torque flywheel nut to
4. Rotate flywheel so that magnet is away from coil
mounting area.
5. Install ignition coil and push ignition coil towards
cylinder head as far as it will go then temporarily
tighten one screw.
6. Rotate flywheel until magnet is under coil
laminations.
7. Place thickness gauge
between magnet and coil laminations (Figure 75).
Fig. 75
8. Loosen mounting screw so magnet will pull
ignition coil down against thickness gauge.
Torque screws to
9. Rotate flywheel to remove thickness gauge.
10. Install ground wire assembly to ignition coil.
Route wire between cylinder head fins as shown
(Figure 76).
Fig. 76
Page 26
.
33 lb-ft. (44.7 Nm)
.010" (0.25mm)
.
90 lb-in. (10.0 Nm)
INSTALL AIR VANE AND GOVERNOR
1. Install air vane governor bracket to cylinder
(Figure 77).
a. Torque screw
Fig. 77
2. Assemble governor link to lever on air vane from
the back side as shown (
3. Insert air vane into boss in governor bracket until
retainer snaps over boss on governor bracket.
Check that air vane pivots freely.
Fig. 78
2-Cycle Snow Engine
Section 5 - Engine Assembly
to
.
30 lb-in. (3.0 Nm)
Figure 78).