2-Cycle Snow Engine
Section 3 - Engine Disassembly
SECTION 3
ENGINE DISASSEMBLY
REMOVE SHROUD
1. Disconnect spark plug wire.
2. Remove the two screws
to the base (Figure 17).
3. Remove the nuts and washers
(Figure 17).
720-002
Fig. 17
REMOVE CARBURETOR
NOTE
: We strongly recommend cleaning the
exterior of the carburetor before removal from
the engine.
1. Remove fuel line and drain; remove the fuel tank.
(On some snow throwers, it will be necessary to
remove the lower shroud to access the carburetor
and fuel line.)
2. Disconnect the primer tube from the carburetor
fitting and remove the choke cable.
that attach the shroud
from the studs
3. Slide the air vane from its mounting bracket
shown (Figure 18).
Fig. 18
4. Remove the two screws
carburetor to the intake pipe and discard the
gasket (Figure 19).
Fig. 19
5. Pull the carburetor assembly down and away from
the engine and set aside.
as
that secure the
Page 9