Carburetor Disassembly - Briggs & Stratton 276535 Repair Manual

2-Cycle Snow Engine
Section 4 - Engine Overhaul

CARBURETOR DISASSEMBLY

NOTE
: The exterior of the carburetor should be
cleaned before removal from the engine.
1. Using needle nose pliers, gently pull the throttle
plate out of the throttle shaft (Figure 38). Note
the orientation of the small protrusions on the
throttle plate as you pull it out.
Fig. 38
2. Remove throttle shaft.
3. Set the choke lever to the full-open detent (Figure
39).
Fig. 39
4. Using needle nose pliers, gently pull the choke
plate from the choke shaft (Figure 40). Note the
orientation of the small protrusions on the choke
plate as you pull it out.
Fig. 40
5. Remove the four bowl retaining screws
bowl gasket , and the bowl
Discard the bowl gasket.
Fig. 41
, the
(Figure 41).
Page 15