General Maintenance - Dirt Devil Upright vacuum cleaner Owner's Manual

GENERAL MAINTENANCE

WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.
DEBRIS DEBRIS REMOVAL/
REMOVAL/HOSE NOZZLE GUARD
1. 2. 3.
DIRT
INLET
DEBRIS REMOVAL/POWER BRUSH TOOL
4. 5.
LOCKING RING
Rotate locking ring 180˚ and Pivot lower housing and
turn Power Brush Tool over. remove clog.
• Check to see if dirt container is full; empty if
needed.
• Plug cleaner in and check to see if there is any
suction at end of hose. If there is suction at
end of hose, move on to Diagram 4. If there is
no suction at the end of hose, follow these
steps:
1. Unwrap hose from caddy. Remove
obstruction. Check lower hose curve and
remove obstruction (Diagram 1).
2. Remove dirt container (Pg. 9) and check dirt
container inlet located on cleaner (Diagram 2).
3. Remove nozzle guard (see Diagram 3) by
removing the three (3) screws. Remove
obstructions (Refer to Pages 10 & 11 for belt
and brushroll removal and replacement).
6.
TABS
To reassemble, be sure tabs are
engaged. Pivot the lower housing
closed.
12