Initial Set Mode - Icom IC-V85 Instruction Manual

11
SET MODES

■ INITIAL SET MODE

The
INITIAL SET MODE
to set seldom-changed settings. In this way, you can "cus-
tomize" transceiver operations to suit your preference and op-
erating style.
D D Entering INITIAL SET MODE
q While pushing and holding [Y Y ] and [Z Z ], turn power ON.
w Push [Y Y ] or [Z Z ] to select the desired item.
e Rotate [VOL] to select the condition or value.
• To exit
INITIAL SET MODE
PWR
A D
B C
FUNC CALL MR CLR
TONE BANK
P.BEEP T.SCAN
1
2 3
DUP SKIP OPT
SCAN
4 0
5 6
PRIO SET H/M/L
7 8 9 ENT
51
POWER ON
AT
is accessed at power on and allows you
✱
, push [ ] (or [CLR]).
ENT
Enter Set Exit
[VOL]
PWR
D D Key-touch beep
Turns key-touch beep emission ON (Beep level 1 to 3) or
OFF.
NOTE: The pocket beep level (Beep level 1 to 3 or OFF)
also changes as this setting.
D D Time-out timer
To prevent accidental prolonged transmission, etc., the trans-
ceiver has a time-out timer. This function cuts a transmission
OFF after 1–30 min. of continuous transmission. This timer
can be cancelled.
• tOt.OF : The time-out timer is turned OFF.
• tOt. 1–30: The transmission is cut OFF after the set period
elapses. (default: 3)
• BE CAREFUL! The transceiver will become hot when
this time-out timer function is turned OFF and transmis-
sion is made for long periods.
• NOTE: When the battery pack (BP-227) becomes hot
from continuous transmittion, etc., the battery's protection
circuit may activate to protect the battery itself and then
shut off the transceiver power until it has cooled down.
(default: 3)