10
PAGER/CODE SQUELCH
■ Pager operation
D Calling a specific station
q Program the code channel in advance (p. 44).
w Set the operating frequency.
• Set the volume and squelch to the desired level as in normal op-
eration.
e Push [FUNC], then push [
• Rotate [VOL] to select "dtm.PG," if "dtm.CS" or "dtm.OF" ap-
pears.
A
OPT
Push
0
FUNC
r Select the desired transmit code channel:
➥ Push and hold [
lection mode.
➥ Rotate [VOL] (or push [Y Y ]/[Z Z ]) to select the desired
code channel.
➥ Push [✱
] (or [CLR]) to return to previous mode.
ENT
• 100 MHz digit shows "P."
t Push [PTT] to transmit the pager code.
y Wait for an answer back.
• When the transceiver receives an answer back code, the func-
tion display shows the other member's ID or group code.
45
](0).
OPT
](0) for 1 sec. to enter the code se-
OPT
u After confirming a connection, push [FUNC] and [
to enter
OPTION SET MODE
code squelch operation "dtm.CS," or non-selective calling
system "dtm.OF."
• DO NOT push any digit keys while code channels C0 to C6 are
displayed, otherwise code channel contents will be changed.
i Communicate with the other party as normal: push [PTT]
to transmit; release to receive.
D Waiting for a call from a specific station
q Set the operating frequency.
w Push [FUNC], then push [
➥ Rotate [VOL] to select "dtm.PG," if "dtm.CS" or
"dtm.OF" appears.
➥ Push [✱
] (or [CLR]) to return to previous mode.
ENT
• 100 MHz digit shows "P."
e Wait for a call.
• When receiving a call, the caller's ID or group code appears as
shown at next page.
• DO NOT push any digit keys while code channels C0 to C6 are
displayed, otherwise code channel contents will be changed.
r Push [PTT] to send an answer back call and display the
operating frequency.
t After confirming a connection, push [FUNC] and [
to enter
OPTION SET MODE
code squelch operation "dtm.CS," or non-selective calling
system "dtm.OF."
OPT
, then rotate [VOL] to select the
](0).
OPT
OPT
, then rotate [VOL] to select the
](0)
](0)