Tone Scan - Icom IC-V85 Instruction Manual

■ Tone scan

By monitoring a signal on a repeater, or using pocket beep or tone
squelch function, you can determine the tone frequency necessary to
access a repeater or open the squelch.
q Set the frequency to be checked for a tone frequency or code.
w Push [FUNC], then push [
• Repeat several times to select the type of tone to be scanned. (One of " ,"
" " or " " appears)
D
• Tone scan may be used even if the tone condition or type is not selected.
A
TONE
Push 1
FUNC
e Push [FUNC], then push [
• To change the scanning direction, push [Y Y ] or [Z Z ].
A T.SCAN
3
Push
FUNC
](1).
TONE
](3) to start the tone scan.
.
T SCAN
SUB AUDIBLE TONES
r When the CTCSS tone frequency or DTCS code
is matched, the squelch opens and the tone fre-
quency or code is temporarily programmed into
the selected mode such as memory or call chan-
nel.
• The tone scan pauses when a CTCSS tone fre-
quency or 3-digit DTCS code is detected.
• The decoded CTCSS tone frequency or 3-digit DTCS
code is used for the tone encoder or tone encoder/de-
coder depending on the selected tone condition or
type in step w.
- No indication : Cannot be used for operation.
- " " : CTCSS tone encoder
- " " : CTCSS tone encoder/decoder
- " " : DTCS tone encoder/decoder
D
t Push [CLR] to stop the scan.
9
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
42