Initial Set Mode Programming; Initial Set Mode Items; Auto Repeater (For Only The Usa Version); D Initial Set Mode Operation - Icom IC-V86 Advanced Manual

9
SET MODES

Initial Set mode programming

The initial Set mode can be accessed at power ON,
and allows you to set seldom-changed settings. In this
way, you can "customize" the transceiver to suit your
preference and operating style.

Initial Set mode items

Extra High Power
Select whether or not to display and select EXH (Extra
High) as the highest power of the transceiver.
• EXH.OF: Displays and selects High as the highest
power level of the transceiver.
• EXH.On: Displays and selects Extra High as the
highest power level of the transceiver.
Key-touch beep
Settheconfirmationbeepstobetween1and3.
ToturnOFFtheconfirmationbeeps,select"bEP.OF."
• When changing the beep level, beeps sound at the
level.
Time-out timer
To prevent accidental prolonged transmission, the
transceiver has a time-out timer. The function inhibits
continuous transmissions longer than the set time
period (1 ~ 30 minutes).
• tot.OF: Turns OFF the function.
• tot. 1 ~ 30: Transmission is cut OFF after the set
time period ends.
Approximately 10 seconds before the Time-out timer
is activated, the transceiver emits a beep tone as a
warning.
BE CAREFUL! When using the BP-263
, the batteries will become hot if this Time-out
case
Timer function is turned OFF or set to a long time
period, and transmission is made for long periods.
(Default: EXH.OF)
(Default: bEP. 2)
(Default: tot. 5)
battery
9-5

D Initial Set mode operation

1. While holding down [Y] and [Z], hold down [ ] for
1 second to enter the Initial Set mode.
2. Push [Y] or [Z] to select the desired item.
3. Rotate [VOL] to select an option or value.
4. Push [# ENT] to exit the initial Set mode.

Auto Repeater (For only the USA version)

The Auto Repeater function automatically turns the
duplex setting and tone encoder ON or OFF when
the operating frequency falls within or outside of the
general repeater output frequency range (145.200 ~
145.495 MHz, 146.610 ~ 146.995 MHz, and 147.000
~ 147.395 MHz). The frequency offset and repeater
tone frequency are not changed by the Auto Repeater
function; reset these frequencies, if necessary.
• RPt.OF: Turns OFF the function.
• RPt.R1: Activates only duplex.
• RPt.R2: Activates duplex and tone.
Auto power-OFF
The transceiver can be automatically turned OFF,
whennokeyoperationisperformedforthespecified
period of time. 30 minutes, 1 hour, 2 hours and OFF
are selectable.
• POF.OF: Turns the function OFF.
• POF.30/1H/2H: The transceiver is automatically
turned OFF, when no key operation
isperformedforthespecifiedtime
period.
NOTE: The setting is retained, even if the
transceiver is turned OFF by the Auto Power OFF
function. To cancel the function, select "POF.OF."
(Default: RPt.R1)
(Default: POF.OF)