Skip Channels; Scan Resume Condition - Icom IC-V85 Instruction Manual

8
SCAN OPERATION

■ Skip channels

In order to speed up the scan rate, you can select memory
channels you don't wish to scan as skip channels.
q Push [MR] to select memory mode, if necessary.
• " X " appears.
w Select a memory channel to set as a skip channel.
ePush [FUNC] and [
and OFF.
• "SKIP" appears when the channel is set as a skip channel.
A
SKIP
Push 6
FUNC
37
](6) to toggle the skip setting ON
SKIP
"SKIP" appears

■ Scan resume condition

When a signal is received during scanning, the scan resume
condition determines what action the transceiver takes. The
transceiver has 2 scan resume conditions available as
illustrated below. Use
SET MODE
suits your needs.
q Push [FUNC], then push [
wPush [Y Y ] or [Z Z ] several times until "SCP" or "SCt" ap-
pears.
e Rotate [VOL] to select the desired scan resume condition.
• Pause scan:
When receiving a signal, scan pauses
on the signal until it disappears. Re-
sumes 2 sec. after the signal disap-
pears.
• Timer scan:
When receiving a signal, scan pauses
on the signal for 5 sec., 10 sec. or 15
sec., then resumes.
r Push [✱
] (or [CLR]) to set and
ENT
exit .
SET MODE
SET MODE
USING
to select the one which best
](8) to enter .
SET SET MODE
Pause scan
Timer scan