HP Pavilion 13 Maintenance And Service Manual page 52

Remove the display assembly:
1. Release the ZIF connector (1) to which the display panel cable is attached, and then disconnect
the display panel cable from the system board.
2. Release the display panel cable from the routing channel (2) built into the bottom cover.
3. Disconnect the WLAN antenna cable (3) from the terminal on the WLAN module.
NOTE:
4. Release the wireless antenna cable from the routing clip (4) built into the bottom cover.
5. Remove the six Phillips PM2.5×5.7 screws (1) that secure the display assembly to the
bottom cover.
44 Chapter 5 Removal and replacement procedures
The 1/black WLAN antenna cable is connected to the WLAN module 1/Main terminal.