®
Invacare
6.5
Electronic Box and Components
WARNING:
Remove Batteries.
WARNING:
Prepare the vehicle by putting it on its side onto a support (not too soft)
so that the underbody under the electronic box can be easily accessed
or, alternatively, jack up vehicle securely.
6.5.1
Disassembling the Electronic Box
1.
Remove all connectors from the electronic box.
2.
Remove the screws securing the box to the
underbody (4 Allen screws).
6.5.2
Disassembling the Components
1.
Before removing any components, mark and take
note of the connections of the components to be
replaced.
2.
Remove P & G Electronics
a)
Remove the two Allen screws at the rear panel
of the casing.
3.
P & G Cable Set with jacks
a)
Remove cable ties and connectors.
b)
Route the new cable harness (also refer to
overview in section 2.2) and secure with cable
ties.
4.
Fuse holder
a)
Take note of fuse position and specifications.
b)
Take off fuse holder cover.
c)
Take out 3 A (lights, indicators) or 15 A
32
Delta II
Service-Anleitung