Transmitter/Receiver Learn Routine - Viper 300 ESP Installation Manual

transmitter/receiver learn routine

The system comes with two transmitters that have been taught to the receiver. The receiver can store up to four
different transmitter codes in memory. Use the following learn routine to add transmitters to the system or to
change button assignments if desired.
When the learn routine has previously been programmed using an optional hand-held system programmer
(p/n 998T) or PC Interface module, it may have been locked. Before proceeding with reprogramming the
learn routine, it must be unlocked by using either p/n 998T or the PC Interface module - this cannot be done
manually with the Valet switch. If the learn routine is locked, transmitters cannot be programmed to the system.
1.
2.
3.
NOTE: If adding a remote, a button must be taught to the unit in the Channel 1 or Channel 4 posi-
tion prior to programming other channels, unless programming to one of the Auto Learn
Configurations.
Press and HOLD the Valet
times corresponding to the channel that is accessed.
CHANNEL NUMBER
1
2
3
4
5
6
7
8
9
*NOTE: For Auto Learn Configurations, see Transmitter Configurations section of this guide.
24
Open a door. (The H1/5 GREEN wire or the H1/7 VIOLET wire must be connected.)
Key. Turn the ignition on. (The YELLOW wire, H1/9 must be connected.)
Select the receiver channel: Press and release the Valet
times necessary to access the desired channel.
® /Program button once more. The siren will chirp and the LED will blink the number of
FUNCTION
Arm/Disarm/Panic
Silent Mode™/Remote Valet
Remote Start or other accessories
Arm only
Disarm only
Panic only
Auto Learn Expanded Configuration* (only with optional 4-button transmitter)
Auto Learn Standard Single Button Arm/Disarm Configuration*
Delete all transmitters
® /Program button the number of
® /Trunk Release
© 2000 Directed Electronics, Inc. Vista, CA
™
WIRE COLOR
RED/WHITE
WHITE/BLUE