Transmitter/Receiver Learn Routine - Viper 600 ESP Installation Manual

transmitter/receiver learn routine

The system comes with two transmitters that have been taught to the receiver. The receiver can store up to 4
different transmitter codes in memory. Use the following learn routine to add transmitters to the system or to
change button assignments if desired.
Using the optional DEI Bitwriter or PC Interface, the learn routine may be locked. Make sure the learn routine is
unlocked before programming features. If the siren generates one long chirp when attempting to program the
unit, the learn routine is locked and must be unlocked using the DEI Bitwriter or PC before proceeding.
1. Open a door: The GREEN wire, H1/5, or the VIOLET, H1/7 must be connected.
2. Turn the ignition on: The YELLOW wire, H1/9 must be connected.
3. Select the receiver channel: Press and release the Valet®/Program button the number of
times necessary to access the desired channel.
NOTE: If adding a remote, a button must be taught to the unit in the Channel 1 or Channel 4 posi-
tion prior to programming other channels.
Press and hold the Valet®/Program button once more. The siren will chirp and the LED will blink the number of
times corresponding to the channel that is accessed.
CHANNEL NUMBER
1
2
3
4
5
6
7
8
9
*NOTE: For Auto Learn Configurations, see Transmitter Configurations section of this guide.
© 1999 Directed Electronics, Inc. Vista, CA
FUNCTION
Arm/Disarm/Panic
Silent Mode™/Remote Valet
Remote Start or other accessories
Arm only
Disarm only
Panic only
Auto Learn Standard Configuration*
Auto Learn Single Button Arm/Disarm Configuration*
Delete all transmitters
® /Trunk Release
WIRE COLOR
RED/WHITE
WHITE/BLUE
35