Remote Control Learn Routine - Viper 7900 Installation Manual

remote control learn routine

The system comes with one remote control that is programmed to the antenna. The system can store up to
4 different remote control codes in memory. Use the following learn routine to add remote controls to the
system or to change button assignments if desired.
The learn routine may be locked if previously programmed using the Bitwriter®. If the siren generates one
long chirp when attempting to program the unit, the learn routine is locked and must be unlocked using
the Bitwriter® before proceeding.
The Valet/Program switch, plugged into the blue port, is used for programming. There is a basic sequence
to remember whenever programming this unit: Door, Key, Choose, Transmit and Release.
© 2006 Directed Electronics—all rights reserved
1. Open a door. (The GREEN wire, H1/8, or the VIOLET, H1/6 must
be connected.)
2. key. Turn the ignition to the ON position.
3. Choose. Within 10 seconds, press and release the Program switch
the number of times corresponding to the desired function step
listed below. Once you have selected the function step, press the
switch once more and HOLD it. The LED will flash and the siren will
chirp to confirm the selected functional step. Do not release the
Program switch.
™
41