Plug-In Harnesses; Super Bright Led; Valet /Program Switch; Programmer Interface - Viper 300 ESP Installation Manual

plug-in harnesses

super bright LED, 2-pin white plug
The super bright LED operates at 2V DC. Make sure the LED wires are not shorted to ground as the LED will be
damaged. Multiple LED's can be used, but they must be wired in series. The LED fits into a 9/32 inch mounting
hole. Be sure to check for clearance prior to drilling the mounting hole.
valet ® /program switch, 2-pin blue plug
The Valet ® /Program switch should be accessible from the driver's seat. It plugs into the blue port on the side of
the unit. Since the system features Valet
Consider how the switch will be used before choosing a mounting location. Check for rear clearance before drilling
a 9/32-inch hole and mounting the switch.The GRAY wire in the two-pin plug may also be used as a (+) ghost
switch input and can be connected to any (+) switch in the vehicle. (See Feature Descriptions section of this
guide.)
programmer interface, 3-pin black plug
The black three pin port is provided for personal computer programming of the unit. When using the DEI Bitwriter
(P/N 998T) or optional PC Interface Module (P/N 996T) it is possible to configure any and all of the program-
mable functions. The PC Interface Module works with an IBM compatible PC. (The 998T does not require the IBM
compatible PC.) For more information please refer to the guide packaged with the programmer. This port can also
be used to interface the Valet
© 2000 Directed Electronics, Inc. Vista, CA
® by using the remote transmitter, the switch can be well hidden.
® Car#Com (DEI P/N 820T) with the security system.
15