Viper 300 ESP Installation Manual page 31

I System will not passively arm until it is remotely armed and then disarmed:
Are the door inputs connected? Is a blue wire connected to the door trigger wire in the vehicle? Either the green
H1/5 or the violet H1/7 should be used instead.
I Door input does not respond with the progressive trigger, but with immediate full alarm:
What zone does the LED indicate? If the LED indicates that the impact sensor caused the trigger, the sensor may
be detecting the door opening. Reducing the sensitivity or relocating the sensor can often solve this problem.
If the LED indicates that the door caused the trigger, you may have programmed the progressive door trigger off.
(See Feature 2-4 in the Feature Descriptions section of this guide.)
I The Valet
® switch does not work:
Is it plugged into the correct socket?
Check the System Features Learn Routine for the programmed Valet pulse count.
I Status LED does not work:
Make sure that it is plugged in. (See Plug-In Harnesses section of this guide.) Is the LED plugged into the correct
socket?
31
© 2000 Directed Electronics, Inc. Vista, CA