Changing The Management Data Encryption Key; Setting Can Be Made Only From The Control Panel - Konica Minolta bizhub 750 Security Manual

Administrator Operations

2.10.6 Changing the Management Data Encryption Key

Note
When the main power switch is turned off, then on again, wait at least 10
seconds to turn it on after turning it off. if there is no wait period between
turning the main power switch off, then on again, the machine may not
function properly.
Here is the sequence, through which the main power switch and sub
power switch are turned on and off:
Turn off the sub power switch
on the main power switch
Do not leave the machine with the Administrator Setting mode setting
screen left shown on the display. If it is absolutely necessary to leave the
machine, be sure first to log off from the Administrator Setting mode.
<Setting can be made only from the control panel>
0 For the procedure to call the Management Data Encryption Key entry
screen to the display, see steps 1 through 4 of "Setting the Management
Data Encryption Key" on page 2-64.
1
Call the Management Data Encryption Key entry screen to the display.
2
Enter the currently registered 20-digit Management Data Encryption
Key from the keyboard and keypad.
– Press the [C] key to clear all characters.
– Touch [Delete] to delete the last character entered.
– Touch [Shift] to show the upper case/symbol screen.
– Touch [Cancel] to go back to the HDD Setting screen.
750/600
→
Turn off the main power switch
→
Turn on the sub power switch
2
→
Turn
2-73