Removing And Installing The Support Bracket - IBM 8649 - Eserver xSeries 225 Maintenance And Troubleshooting Manual

Removing and installing the support bracket

When working with some devices, such as hard disk drives, adapters, and memory
modules, you must first remove the support bracket to access the device.
Complete the following steps to remove the support bracket:
1. Review the safety information beginning on page 129 and "Installation
2. Remove the side cover ("Removing the side cover" on page 36).
3. If your server comes with a standard support bracket similar to the support
38
IBM xSeries 225 Types 8649: Hardware Maintenance Manual and Troubleshooting Guide
guidelines" on page 33.
bracket in the following illustration, complete the following steps:
a. Pull out on the rear end of the support bracket at a 45° angle.
b. Disengage the front end of the support bracket from the server and set the
bracket aside.