Removing The Bezel; Removing And Installing The Adapter-Support Bracket - IBM 8671 - Eserver xSeries 235 Maintenance And Troubleshooting Manual

Removing the bezel

The following illustration shows how to remove the bezel from a rack configuration
server.
Complete the following steps to remove the bezel:
1. Review the information in "Installation guidelines" on page 45, "Handling
2. Remove the server cover and locate the bezel-release lever.
3. Press the bezel-release lever to the unlocked position as indicated on the lever.
4. Pull the right side of the bezel away from the chassis; then, slide the bezel to
5. Remove the bezel from the server and store the bezel in a safe place.

Removing and installing the adapter-support bracket

When working with some options, you must first remove the adapter-support
bracket to access certain components or connectors on the system board.
Note: The adapter-support bracket is attached to the center-fan bracket in the
Complete the following steps to remove the adapter-support bracket:
1. Review the information in "Installation guidelines" on page 45, "Handling
58
xSeries 235 Type 8671: Hardware Maintenance Manual and Troubleshooting Guide
static-sensitive devices" on page 46, and "Safety information" on page 169.
the right to disengage the tabs.
server. Both brackets are removed and installed together as a single unit.
static-sensitive devices" on page 46, and "Safety information" on page 169.
Bezel-release lever
Bezel