Connecting The Cables - IBM eServer xSeries 226 Type 8648 Option Installation Manual

Note: The rear adapter retaining bracket rests against the server side cover. You
might find it easier to lay the server on its side to replace the side cover.
Complete the following steps to replace the side cover:
1. Before installing the cover, check that all cables, adapters, and other
2. Make sure the cover-release latch is in the unlocked (opened) position.
3. Insert the tabs inside the cover into the slots on the server chassis.
4. Make sure that each tab on the side cover is in its corresponding slot.
5. Close the cover-release latch to secure the side cover in place.
6. Lock the side cover.

Connecting the cables

If the server cables and connector panel have color-coded connections, match the
color of the cable end with the color of the connector. For example, match a blue
cable end with a blue panel connector, a red cable end with a red connector, and
so on.
Attention:
The following illustration shows the input/output (I/O) connectors on the server.
Note: The power supply might be different on some models.
Power cords
Mouse
Keyboard
Parallel
Serial 1
Video
USB 1
USB 2
Ethernet
Serial 2
External SCSI
knockout
42
xSeries 226 Type 8648: Option Installation Guide
components are installed and seated correctly and that you have not left loose
tools or parts inside the server
To prevent damage to equipment, connect the power cords last.