IBM eServer xSeries 226 Type 8648 Option Installation Manual page 44

11. Connect required cables to the adapter. Route cables so that they do not block
12. If you have other adapters to install or remove, do so now.
13. If you have installed a full-length adapter, rotate the front adapter-support
14. Reinstall the rear adapter-retention bracket; then, rotate the bracket to the
15. If you have other options to install, do so now; otherwise, replace the
32
xSeries 226 Type 8648: Option Installation Guide
Rear adapter-
retaining
bracket
Expansion-slot
cover
Adapter
the flow of air from the fans. If you are installing an optional SCSI adapter, see
"Cabling an optional SCSI adapter" on page 33 for additional information.
bracket to the closed (locked) position.
closed (locked) position.
Note: If any adapters in the server are large or have heavy cables attached to
them, you can remove the rear adapter-retention bracket and secure all of the
adapters with expansion-slot screws. The expansion-slot screws are stored on
the frame-support bracket.
frame-support bracket (see "Removing and installing the support bracket" on
page 12) and go to "Completing the installation" on page 41.
Front adapter-
retaining bracket