IBM IntelliStation A Pro 6224 Hardware Maintenance Manual And Troubleshooting Manual page 64

Complete the following steps to replace the battery:
1. Read the safety information in Appendix B, "Safety information," on page 117,
2. Follow any special handling and installation instructions that come with the
3. Turn off the computer and all attached devices. Disconnect all external cables
4. Remove the battery:
Figure 23. Removing the battery
5. Insert the new battery:
Figure 24. Installing the battery
6. Replace the support bracket (see "Replacing the support bracket" on page 29).
7. Replace the cover and connect the cables.
8. Turn on the computer.
9. Start the Configuration/Setup Utility program and set configuration parameters.
54
IntelliStation A Pro Type 6224: Hardware Maintenance Manual and Troubleshooting Guide
"Installation guidelines" on page 25, and "Handling static-sensitive devices" on
page 25.
replacement battery.
and power cords; then, remove the computer cover and the support bracket
(see "Replacing the side cover" on page 27 and "Replacing the support bracket"
on page 29).
a. Use a fingernail to press the top of the battery clip away from the battery
(see Figure 23). The battery pops up when released.
b. Use your thumb and index finger to lift the battery from the socket.
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
b. Press the battery down into the socket (Figure 24) until it clicks into place.
Make sure that the battery clip holds the battery securely.
v Set the system date and time.
v Set passwords if necessary.
v Save the configuration.