IBM IntelliStation A Pro 6224 Hardware Maintenance Manual And Troubleshooting Manual page 52

Figure 15. Rotating the drive cage
10. If you are replacing a drive:
42
IntelliStation A Pro Type 6224: Hardware Maintenance Manual and Troubleshooting Guide
3. Select the bay in which you want to install the drive.
4. Check the instructions that come with the drive to determine whether you must
set any switches or jumpers on the drive. If you are installing a SCSI device,
make sure that you set the SCSI ID for that device.
5. Turn off the computer and all attached devices (see "Turning off the computer"
on page 5); then, disconnect all power cords and external cables.
6. Remove the side cover (see "Replacing the side cover" on page 27).
7. Remove the support bracket (see "Replacing the support bracket" on page 29).
4
139
8. Grasp the drive cage and rotate the cage out of the computer until it locks into
place with the drive-cage retention tab (see Figure 15).
Note: You might need to disconnect the power cables from the drives before
you rotate the cage all the way.
The open ends of the drive slots and installed drives will face you. Make sure
that the drive cage locks into place over the drive-cage retention tab by
rotating the drive cage all the way out of the computer.
9. If you are installing a new drive in an empty bay, slide the existing drive tray
out of the drive bay.
a. Slide the existing drive out of the drive bay.
4
139