Chapter 2: Getting To Know The Phone Adapter; Back Panel Ports; Figure 2-1: Back Panel - Linksys VONAGE PAP2 Ver. 2 Installation And Troubleshooting Manual

Chapter 2: Getting to Know the Phone Adapter

Back Panel Ports

The Phone Adapter's ports are located on the back panel.

Figure 2-1: Back Panel

Reset Button There are two ways to reset the Phone Adapter's factory defaults. Either press the Reset
Button for 30 seconds, or restore the defaults from the Web-based Utility.
PHONE 1/2 Port The PHONE 1/2 port allows you to connect your telephone or fax machine to the Phone
Adapter using an RJ-11 telephone cable (not included). Use the PHONE 1 port for the
primary Vonage line, and use the PHONE 2 port if you have a second Vonage line.
INTERNET Port The INTERNET port allows you to connect the Phone Adapter to your router or gateway
using a Category 5 (or better) Ethernet network cable.
Power Port The Power port is where you will connect the included power adapter.
Chapter 2: Getting to Know the Phone Adapter
Back Panel Ports
Phone Adapter with 2 Ports for Voice-over-IP
NOTE: These Phone ports do
not carry any voltage.
IMPORTANT: Use only the
included power adapter to
power the Phone Adapter. If you
use a different power adapter,
the Phone Adapter may be
damaged or may not work.
3