Advertisement
3.
C C H H A A N N N N E E L L N N U U M M B B E E R R
1
2
3
4
5
6
7
8
9
10
11
12
13
14
* * N N O O T T E E : : For Auto Learn Configurations, see Transmitter Configurations section of this guide.
** * N N O O T T E E : : If any button from a known transmitter is programmed to Channel 13, all trans-
mitters will be erased from memory and will revert to the default feature settings. This
is useful in cases where the customer's transmitters are lost or stolen.
4.
5.
You can advance from programming one channel to another by releasing the Valet/Program switch and tapping
it to advance channels and then H H O O L L D D I I N N G G it. For instance: You have programmed Channel 1 and you want to
program Channel 2. Release the Valet/Program switch. Press it one time and release it to advance from Channel
1 to Channel 2. Now, press and H H O O L L D D the Valet/Program switch. The LED will flash two times and the horn will
honk twice (if connected). As before, do not release it.
3 3 6 6
C C h h o o o o s s e e . . Within 10 seconds, press and release the Program switch the number of times cor-
responding to the desired channel listed below. Once you have selected the channel, press
the switch once more and H H O O L L D D it. The LED will flash and the horn will honk (if connected)
to confirm the selected channel. Do not release the Program switch.
F F U U N N C C T T I I O O N N
Auto Learn Standard Configuration* * (default)
Arm only
Disarm only
Silent Mode™/Remote Valet/Trunk Release
Remote Start
Channel 4
Channel 5
Channel 6
Short Run/Turbo
Timer Mode
Arm/Disarm/Panic
Panic only
Defogger Control
Delete all transmitters**
T T r r a a n n s s m m i i t t . . While H H O O L L D D I I N N G G the Valet/Program switch, press the button on the transmitter
that you would like to control the selected receiver channel. The unit will chirp to confirm
that the code has been successfully programmed. It is not possible to teach a transmitter
button to the system more than once.
R R e e l l e e a a s s e e . . Once the code is learned, the Valet/Program switch can be released.
W W I I R R E E C C O O L L O O R R
RED/WHITE
VIOLET/BLACK
WHITE/BLACK
© 2005 Directed Electronics—all rights reserved
Advertisement
