Advertisement
H H 3 3 / / 3 3 B B R R O O W W N N ( ( + + ) ) b b r r a a k k e e s s w w i i t t c c h h i i n n p p u u t t , , z z o o n n e e 1 1
This wire MUST be connected to the vehicle's brake light wire. This is the wire that shows (+) 12V when the brake
pedal is depressed. The remote start will be disabled or shut down any time the brake pedal is depressed. This
wire will also trigger the security system if the brake pedal is pressed while the system is armed and will report
Zone 1.
H H 3 3 / / 4 4 G G R R A A Y Y ( ( - - ) ) h h o o o o d d p p i i n n s s w w i i t t c c h h i i n n p p u u t t , , z z o o n n e e 1 1
This wire MUST be connected to hood pinswitch. This input will disable or shut down the remote start when the hood
is opened. It will also trigger the security system if the hood is opened while the system is armed and report Zone 1.
H H 3 3 / / 5 5 B B L L U U E E / / W W H H I I T T E E ( ( - - ) ) s s t t a a t t u u s s o o u u t t p p u u t t
This wire supplies a 200mA output as soon as the module begins the remote start process. The H3/1 BLUE wire
can also be used to activate the defogger trigger (latched/pulsed) 10-seconds after the remote start engages.
(See the Feature Descriptions section in this guide for details about programming this output.)
h h o o r r n n , , c c h h a a n n n n e e l l 6 6 h h a a r r n n e e s s s s ( ( H H 4 4 ) ) w w i i r r e e
c c o o n n n n e e c c t t i i o o n n g g u u i i d d e e
H H 4 4 / / 1 1 O O R R A A N N G G E E / / B B L L A A C C K K 2 2 0 0 0 0 m m A A p p r r o o g g r r a a m m m m a a b b l l e e ( ( - - ) ) c c h h a a n n n n e e l l 6 6 o o u u t t p p u u t t
This wire provides a (-) 200mA output whenever the transmitter button(s) controlling Channel 6 is pressed. (see
also the Feature Descriptions section and previous channel 5 description):
I I M M P P O O R R T T A A N N T T ! ! Never use this wire to drive anything but a relay or a low-current input! This tran-
sistorized output can only supply 200 mA, and connecting directly to a solenoid, motor, or other
high-current device will cause the module to fail.
H H 4 4 / / 1 1 B B R R O O W W N N 2 2 0 0 0 0 m m A A ( ( - - ) ) h h o o r r n n o o u u t t p p u u t t
This wire provides a (-) 200mA output to the horn when programmed.
I I M M P P O O R R T T A A N N T T ! ! Never use this wire to drive anything but a relay or a low-current input! This tran-
sistorized output can only supply 200 mA, and connecting directly to a solenoid, motor, or other
high-current device will cause the module to fail.
2 2 6 6
© 2005 Directed Electronics—all rights reserved
Advertisement
