Decorative Accessory Installation - Empire Comfort Systems VFL20IN3 Installation Instructions And Owner's Manual

Loft vent free fireplace insert
Hide thumbs Also See for VFL20IN3:
Table of Contents

Advertisement

DECORATIVE ACCESSORY INSTALLATION

Failure to position the parts in accordance with the dia-
grams and instructions below or failure to use only parts
specifically approved for use with this heater may result in
property damage or personal injury.
Notice: The Loft series burners may be operated with or
without the Decorative accessory options. Follow the
directions below should you choose to enhance your
Loft burner with any one of the available decorative
options.
DECORATIVE GLASS ACCESSORY pLACEMENT
The Decorative Glass options are available in various colors and
package sizes. Choose the size appropriate for your fireplaces.
See list on page 9.
Use of gloves and eye protection is required while applying
the decorative glass.
INSTALLATION
1.
Application of the Decorative Glass should only be performed
after the Loft burner has been fully installed, secured and test-
ed for leaks. If operating the burner with a Remote Control,
make sure all batteries are installed and that the Loft burner
operates with the remote correctly.
3.
To install the Decorative Glass, cut off a corner of the plastic
bag and proceed to apply the glass to the rear shelf on the
Loft burner (area behind the burner). Apply only enough glass
to the Top Cover to cover the black metal surfaces. Do not
allow the glass to fall around the burner tube. See Figures 20
to 21. Apply the remaining decorative glass to the front sloped
surface of the Top Cover. Start by placing the glass along the
front edge of the top cover, then gradually place the glass
up the sloped top until completely covered. Do not allow the
glass to fall around the burner tube. See Figure 22.
Glass must not be placed around the ends of the Loft burn-
er assembly that would restrict air flow, or cover the gas
valve.
28040-3-0511
WARNING
CAUTION
CAUTION
DECORATIVE GLASS
GLASS MUST NOT BE PLACED ON TOP OF OR
NEXT TO BURNER. GLASS TO BE PLACED ONLY
TO THE OUTSIDE OF THE FLANGED OPENING.
Figure 20
Figure 21
Figure 22
Page 23

Advertisement

Table of Contents
loading

Table of Contents