Appliance Preparation; Top Vent - Heat & Glo SL-750TRS-IPI-E Owner's Manual

7 7

Appliance Preparation

WARNING
Fire Risk
Once appliance is setup for top or rear venting, it
CANNOT be changed at a later time.
If vent cap and components previously removed
are improperly reinstalled, a fi re may result.
A. Top Vent
CAUTION
Sharp Edges
• Wear protective gloves and safety
glasses during installation.
2 SCREWS
Figure 7.1 For top vent, remove the two screws holding the
top heat shield in place. For rear vent, see Section 7B.
WARNING
Fire Risk
Do not remove heat shield.
Elevated header temperatures may cause a fi re.
Figure 7.2 Rotate the top heat shield to the vertical
position as shown above. The heat shield must remain in
the vertical position.
30 Heat & Glo • SL-750TRS-IPI-E, SL-550TRS-IPI-E, SL-350TRS-IPI • 2120-901 Rev. F • 9/08
2 SCREWS
Figure 7.3 Replace the two screws as shown.
Note: Actual unit may look different than the fi replace shown
in this section.
Figure 7.4 Remove the vent cap.
Figure 7.5 Remove the insulation basket and white insula-
tion from the center vent pipe.