Utility Commands; Exit Command; Help Command; History Command - IBM Remote Supervisor Adapter II User Manual

v All commands have the -h, -help, and ? options, which give syntax help. All of
v Some of the commands listed in the following sections might not be available. To

Utility commands

The utility commands are as follows:
v exit
v help
v history

exit command

Description
Use the exit command to log off and end the command-line interface session.

help command

Description
Use the help command to display a list of all commands with a short description for
each. You can also type ? at the command prompt.

history command

Description
Use the history command to display an indexed history list of the last eight
commands that were issued. The indexes can then be used as shortcuts (preceded
by !) to reissue commands from this history list.
Example
x345RSA> history
x345RSA> !0
-state enabled
-c dthens
-i 192.168.70.125
-g 0.0.0.0
-s 255.255.255.0
-n ASMA00096B9E003A
-r auto
-d auto
-m 1500
-b 00:09:6B:9E:00:3A
-l 00:00:00:00:00:00
x345RSA>
the following examples will give the same result:
x345RSA> power -h
x345RSA> power -help
x345RSA> power ?
see a list of the commands that are supported, use the help or ? option, as
shown in the following examples:
x345RSA> help
x345RSA> ?
0 ifconfig eth0
1 readlog
2 readlog
3 readlog
4 history
Chapter 6. Command-line interface
93