Remote Console - IBM Remote Supervisor Adapter II User Manual

3. Click the Cache tab.
4. Choose one of the following options:

Remote console

A remote console is an interactive graphical user interface (GUI) display of the
server, viewed on your computer. You see on your monitor exactly what is on the
server console, and you have keyboard and mouse control of the console.
To remotely access a server console, complete the following steps:
1. Log in to the Remote Supervisor Adapter II. For more information, see
2. In the navigation pane, click Remote Control. A page similar to the one in the
3. To control the server remotely, use one of the links at the bottom of the Remote
You can close the Remote Control window to disconnect from viewing the server
console.
Notes:
1. Do not close the Remote Control window if a remote disk is currently mounted.
2. If you have mouse or keyboard problems when using Remote Control, see the
3. If you use the remote console to change settings for the Remote Supervisor
82
Remote Supervisor Adapter II SlimLine and Remote Supervisor Adapter II: User's Guide
v Clear the Enable Caching check box. If you choose this option, Java
caching is always disabled.
v Click Clear Caching. If you choose this option, you must click Clear
Caching after each Remote Supervisor Adapter II firmware update.
Chapter 2, "Opening and using the Web interface," on page 5.
following illustration is displayed.
Control page. If you want exclusive remote access during your session, click
Start Remote Control in Single User Mode. If you want to allow other users
remote console (KVM) access during your session, click Start Remote Control
in Multi-user Mode. A new window will open that provides access to the
Remote Disk and Remote Console functionality.
Note: The Remote Disk function does not support multiple users.
See step 7 on page 85 for instructions for closing and unmounting a remote
disk.
help that is available from the Remote Control page in the Web interface.
Adapter II in the server Configuration/Setup Utility program (Advanced Setup →
RSA II Settings), the server restarts the adapter and you lose the remote