Storage; Troubleshooting - Ariens 911173 – LMP Owner's/Operator's Manual

CAUTION: AVOID INJURY. Read
and understand the entire
section before proceeding.
IMPORTANT: NEVER spray unit with high-
pressure water or store unit outdoors. Store
mower in a cool, dry, protected location.
Cleaning
Allow unit to cool. Clean unit thoroughly with
mild soap and low pressure water. Brush off
dirt and debris from all surfaces. Touch up all
scratched surfaces to prevent rust. Matching
touch-up paint is available from your Ariens
Dealer. Do not use abrasives, solvents, or
harsh cleaners.
Inspection
Inspect mower and repair or replace worn or
damaged parts to avoid delays when
beginning use again.
Regularly check all hardware and keep
fasteners tight. Know unit is in safe working
condition.
Grass Bag
Wash out grass bag and allow to dry before
storage. Grass bag may be stored in position
on mower.
PROBLEM
Engine will not
start
Engine is
difficult to
restart
Poor cut quality

STORAGE

Safety

TROUBLESHOOTING

PROBABLE CAUSE
1. Fuel tank empty or low.
2. Spark plug wire loose or off.
3. Engine/Blade control cable
detached, broken, or not
adjusted properly.
1. Mower clogged with grass.
1. Worn blade.
2. Too much grass is being
removed per cutting.
3. Grass is too wet.
4. Mowing speed is too fast.
Engine
Refer to engine manufacturer's
recommendations for storage.
Fuel System
Gasoline left in the fuel system for extended
periods without a stabilizer will deteriorate,
resulting in gum deposits in the system.
These deposits can damage the carburetor
and the fuel hoses, filter and tank. Prevent
deposits from forming in the fuel system
during storage by adding a quality fuel
stabilizer to the fuel. Follow the
recommended mix ratio found on the fuel
stabilizer container.
To treat the fuel system for storage:
1. Add fuel stabilizer according to
manufacturer's instructions.
2. Run engine for at least 10 minutes after
adding stabilizer to allow it to reach the
carburetor.
NEVER store the engine with fuel in the fuel
tank inside of a building with potential
sources of ignition.
CORRECTION
1. Check fuel level. Fill tank if
2. Check connection.
3. Check cable. Adjust, repair
1. Clear clippings from under
1. Check blade (see CHECK
2. Raise cutting height.
3. Allow grass to dry.
4. Mow slower.
EN - 24
necessary.
or replace as necessary.
mower. (Allow the mower to
clear clippings before
shutting off engine.)
MOWER BLADE on
page 18).