3.
Before the first use, remove the Fuel Tank Cap (33) and fill the Fuel Tank (30) with
unleaded gasoline. Then, replace the Fuel Tank Cap. Thereafter, check the
Engine's Fuel Gauge (34) for the amount of unleaded gasoline in the Fuel Tank. If
necessary, refill the Fuel Tank with unleaded gasoline. (See Figure C.)
To Start The Engine:
1.
Make sure the electrical powered tools/equipment that will be used is not
plugged in to the Generator.
2.
Turn the 115 volt AC Circuit Breaker (5) to its "ON" position. (See Figure D.)
3.
Turn on the Fuel Valve (40). (See Figure E.)
4.
Close the Choke Lever (21A) to about 1/8" clearance. (See Figure E.)
CIRCUIT BREAKER
(5)
FIGURE D
CLOSED
CHOKE LEVER
(21A)
FUEL VALVE (40)
REV 03/06
SKU 91213
ON
OFF
OPEN
OFF
ON
PAGE 13
FIGURE E