Pair And Connect A Cell Phone - VTech LS6245 User Manual

IMPORTANT INFORMATION
• Once you have paired a device with the telephone base, you do not have to repeat the pairing procedure again, unless you delete the
device from the paired devices list.
• When adding, removing, or replacing a Bluetooth device on the active devices list, all connected devices are temporarily disconnected until
the procedure is complete. It may take up to two minutes to reconnect.
4.4

Pair and connect a cell phone

Before you begin, make sure that your Bluetooth enabled cell phone is not connected to any other Bluetooth device. Refer to your cell phone
user's manual to learn how to search for or add new Bluetooth devices.
< >
1. Press MENU and /
2. Press SELECT to select SETUP CELL, and then press SELECT.
Note:
If a device is already connected to the telephone base, "CONNECTED DEVS WILL BE TEMP. DISCONNECTED" displays. Press OK to
temporarily disconnect the device and continue the pairing process.
3. Press NEXT to set the telephone base to discoverable mode.
4. Turn on the Bluetooth feature of your cell phone and search for or add new devices.
5. Once your cell phone finds LS6245, select it.
6. Enter the PIN of the telephone base (the default PIN is 0000) into your cell phone to continue the pairing process.
7. When a device is successfully connected, "DEVICE CONNECTED TO BASE", and
Note:
When you already have two devices on the active devices list, press YES to connect to your paired cell phone. You are prompted to replace an
existing device on the active devices list.
The pairing process may take up to one minute. If the pairing process fails, try again.
on the base to select BLUETOOTH.
1 2
and/or displays.
14